Rheometal

RADIO FILTER 1

This part is experimental, used to investigate different possibilities with the Rapid S process. It was successfully cast with alloys ranging from 1,6% Si up to 8,4% Si. The low silicon content enables better and less costly surface treatment process.
     
Machining reduction is a cost driver in the telecom industry. The holes - M2,5 and M3,0 - could be cast to a depth of 8 mm, making them directly usable for self threading screws and eliminating the cost of additional machining.
Line1
Pic1
Pic2
Pic3
Pic5
Pic6
Pic7
Transparent